How To Hang Christmas Lights On Roof Peak

How To Hang Christmas Lights On Roof Peak

How To Hang Christmas Lights On Roof Peak

Hanging Christmas lights on your roof peak will be the finishing touch to your beautifully decorated home during the holiday season. However, they must be attached with close attention to detail, such as the preparation process, homeowner safety consideration, and power recommendation of the lights. Hang sufficiently working lights to adequately cover the entire roof’s ridges the first time with shingle tabs, instead of just hanging your lights randomly. Hanging lights on roof peak can be done in approximately three hours, so ensuring that you take the proper precautionary steps beforehand can prevent you from wasting your time or effort by being displeased with your end result.

What You Need Getting Started

  • Measuring tape
  • Christmas lights
  • Shingle tabs
  • Ladder
  • Extension cord

How to Hang Christmas Lights

Measure the distance of the space that you wish to decorate by placing the end of your measuring tape at one corner of your home’s foundation, and then walk it down the other end. Most light packages come in 25-foot, 50-foot, or 100-foot lengths, which you can divide into the number of feet you have measured to get the number of strings required to cover the entire roof ridges.

Know which outlet works best for providing power to your Christmas lights. Locate the electrical outlet closest to your starting point on the outside of the home, and then look for ones close to that point on the inside of your home. If you have no choice but to use the indoor outlet, slightly open the window and make sure your wires are as thin as possible.

Check each Christmas light string to ensure that each light works by plugging each string into an electrical outlet and inspecting each bulb. Based on your results, replace missing or burned-out bulbs, or the entire string.

Remove bulbs by unscrewing them one at a time. Place the shingle tab in between the bulb and the socket, and screw the bulb back into place. Repeat the process as necessary for each bulb in your set, there should be a bulb and socket on either side of each shingle tab.

Place the ladder to match the height of your roof’s ridge. Slide the ladder’s two sections apart from each other to extend its length, and allow the latch to catch the ladder’s leg when you reach the roof’s ridge. Make sure all four legs are securely set to the ground, and you have enough room to reach the roof’s ridges without standing on the top of the ladder.

Connect an extension cord and route it to the starting point for the lights. Slide the extension cord through a crack in the window closest to the roof ridge, and set it at the corner or base of your home. Plug in the first string of Christmas lights, do not turn on their power yet.

Start hanging the Christmas lights; light the closest shingle at the corner of the roof ridge and place the first shingle tab underneath with the other hand. Don’t worry about releasing your grip, the weight of the shingle will hold the shingle tab in place. Continue inserting the shingle tab under the shingles until you reach the end of the light string.

Hire a Professional

We know…this seems like a pretty extensive and strategic process. You’re not wrong! Christmas light installation altogether takes practice, and requires in-depth knowledge of how to properly install your decor, along with many safety precautions. Luckily, you can hire a professional to take care of your Christmas decorations for you! Lake Norman Pest Control perfectly handles your Christmas decor, with our professionally trained and equipped team. We’re ready and waiting for you. Our customer supports are available all round the clock to answer any of your questions, call us today!

0 Comments

Leave a reply

Your email address will not be published. Required fields are marked *

*